What are Sintered Laps?

Faceting machine discussions here

Moderators: PinkDiamond, John

Post Reply
User avatar
PinkDiamond
Posts: 15411
Joined: Thu Jun 04, 2015 9:30 pm
Location: Ozark Mountains

What are Sintered Laps?

Post by PinkDiamond »

Although expensive, those who cut regularly would likely benefit from investing in one of these. I really didn't know what they were, but Jeff's article explains the benefits and pitfalls of using them. Does anyone here already use a sintered lap? :?:

What are Sintered Laps?
by Jeff R. Graham

Image
Crystalite/Crystalmet 8” Sintered Lap

"Basically, sintered laps are a type of gem faceting lap with diamonds mixed solidly all the way through the lap. The diamond is bonded into the actual metal of the lap, not plated.

Are Sintered Laps Worth It?

Since these metal/diamond laps contain a significant amount of diamonds, they tend to be very expensive. However, if you can afford them or need them for your gem cutting business, they are well worth the money. Few people can probably justify buying them. So, their production numbers run low, too.

What are the Advantages of Sintered Laps?

These laps have three major advantages:

* They cut extremely well.
* Usually, they are quite aggressive, cutting fast and smooth.
* They maintain these qualities for a very long time.

Indeed, sintered laps are said to outlast standard bonded laps by quite a while. I’ve heard claims that they last longer than ten plated laps. While I wouldn’t make that claim, and no real life statistics cover their wear, suffice to say a quality sintered lap will cut and wear a very long time.

What are the Disadvantages of Sintered Laps?

Cost likely ranks as the greatest disadvantage of these laps. Many dealers don’t stock them, either.

In practical terms, how sintered laps wear may pose a problem. Remember, these laps are solid metal/diamond, not plated. So, as time goes by, if the cutter isn’t careful and uses one or two particular areas on the laps, the laps will become grooved and not flat.

Although this type of wear on a sintered lap happens gradually over many years, a lack of flatness poses a major problem for the faceter. To avoid grooving a sintered lap, make sure to use the whole lap surface, carefully, of course. Don’t cut in any one area of the lap excessively.

In general, on a coarse lap, a bit of wear and some non-flatness won’t make a critical difference. On the other hand, on a fine lap, like a 1,200-grit, keeping it flat is very important.

My Personal Experiences

I really like the aggressiveness of sintered laps. However, in my experience, I can’t go directly from a sintered lap to an oxide polish. (In contrast, I can do this when using a well-worn plated lap). So, from a sintered lap, I have to ... "

https://www.gemsociety.org/article/wort ... e_increase
PinkDiamond
ISG Registered Gemologist


· ´¨¨)) -:¦:-¸.·´ .·´¨¨))
((¸¸.·´ ..·´ There are miracles left for you to do .... -:¦:- -:¦:-
-:¦:- ((¸¸.·´* It all begins inside of you. ;)
Post Reply